Lashing Strap Tensioner with cut up to 40 mm
Instructions for using the tensioner with the lashing strap
Lashing Strap Tensioner with cut up to 40 mm
Instructions for using the tensioner with the lashing strap

Lashing Strap Tensioner with cut up to 40 mm

D0800302
€591.51
€488.85 tax excl.

The tensioner is an essential product for a good lashing of your goods. The tensioner with cut up to 40 mm is used to tension the lashing straps held by the buckles.

lashing

protection

Delivery related information

The order delivery may be affected a few days longer than usual on a temporary basis. We apologise for any inconvenience this may cause.

Get a gift bag for purchases over 300€.

You might also like

 

Lashing Strap Tensioner with cut for tensioning lashing straps to secure loads

At Conservatis we have the tensioner with cut up to 40 mm. The instructions for use are explained below:

  1. Once the strap is passed through the buckle, leave a minimum margin of 25 cm to be able to place the tensioner.
  2. Squeeze the tensioner handle and put the strap under the brake lever.
  3. Pull the lever all the way up and feed the top of the strap through the cut system and the tensioner groove.
  4. Move the lever up and down to tighten the lashing strap; keep a minimum margin of 8cm from the buckle to the tensioner.
  5. Squeeze the handle to cut the tether strap, release the brake and remove the tensioner.
Color
Black and blue
Cutting of the tensioner
up to 40 mm

You might also like

Product added to wishlist
Product added to compare.